Connectivity Guide

Example
OS10(config)# ip access-list testflow
OS10(conf-ipv4-acl)# permit udp any any capture session 1
Supported Releases 10.2.0E or later
permit (IPv6)
Congures a lter to allow packets with a specic IPv6 address.
Syntax
permit [protocol-number | icmp | ipv6 | tcp | udp] [A::B | A::B/x | any | host
ipv6-address] [A::B | A:B/x | any | host ipv6-address] [capture | dscp value |
fragment]
Parameters
• protocol-number — (Optional) Enter the protocol number identied in the IPv6 header, from 0 to 255.
• icmp — (Optional) Enter the ICMP address to permit.
• ipv6 — (Optional) Enter the IPv6 address to permit.
• tcp — (Optional) Enter the TCP address to permit.
• udp — (Optional) Enter the UDP address to permit.
• A::B — Enter the IPv6 address in hexadecimal format separated by colons.
• A::B/x — Enter the number of bits that must match the IPv6 address.
• any — (Optional) Set all routes which are subject to the lter:
– capture — (Optional) Capture packets the lter processes.
– dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
– fragment — (Optional) Use ACLs to control packet fragments.
• host ip-address — (Optional) Enter the IPv6 address to use a host address only.
Default Not congured
Command Mode IPV6-ACL
Usage Information The no version of this command removes the lter.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# permit udp any any capture session 1
Supported Releases 10.2.0E or later
permit (MAC)
Congures a lter to allow packets with a specic MAC address.
Syntax
permit {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn
[00:00:00:00:00:00] | any} [protocol-number | capture | cos | vlan]
Parameters
• nn:nn:nn:nn:nn:nn — Enter the MAC address.
• 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not enter a
mask, a mask of
00:00:00:00:00:00 applies.
• any — (Optional) Set which routes are subject to the lter:
– protocol-number — Enter the MAC protocol number identied in the MAC header, from 600 to .
– capture — (Optional) Enter the capture packets the lter processes.
Access Control Lists 731