Connectivity Guide

####################################################################
#
#
# Example OS10 ZTD Provisioning Script
#
#
####################################################################
########## UPDATE THE BELOW CONFIG VARIABLES ACCORDINGLY ###########
########## ATLEAST ONE OF THEM SHOULD BE FILLED ####################
IMG_FILE=”http://50.0.0.1/OS10.bin”
CLI_CONFIG_FILE="http://50.0.0.1/cli_config"
POST_SCRIPT_FILE="http://50.0.0.1/no_post_script.py"
################### DO NOT MODIFY THE LINES BELOW #######################
sudo os10_ztd_start.sh "$IMG_FILE" "$CLI_CONFIG_FILE" "$POST_SCRIPT_FILE"
######################## **END** ###############################
ZTD CLI batch le
Create a CLI batch le that ZTD downloads and executes to congure a switch. The ZTD CLI batch le consists of two sections: PRE-
CONFIG
and POST-CONFIG.
ZTD executes the PRE-CONFIG commands rst using the currently running OS10 image, not the OS10 image specied in the provisioning
script. ZTD saves the
PRE-CONFIG settings to the startup conguration.
If PRE-CONFIG commands are present, ZTD reloads the switch before executing the commands in the POST-CONFIG section. Enter
OS10 conguration commands that require a switch reload, such as
switch-port-profile, in the PRE-CONFIG section. If ZTD
installs a new OS10 image (IMG_FILE), the new image is activated after the reload.
ZTD then executes the POST-CONFIG commands and saves the new settings in the startup conguration. No additional switch reload is
performed.
Example
# PRE-CONFIG
configure terminal
hostname ZTD-3
exit
configure terminal
interface vlan 210
description ztd-jun29-210
no shutdown
exit
# POST-CONFIG
configure terminal
snmp-server contact DellEMC
exit
configure terminal
interface vlan 500
no shutdown
34
Getting Started