Connectivity Guide

• Delete a non-default VRF instance using the following command:
CONFIGURATION
no ip vrf vrf-name
NOTE: You cannot delete the default VRF instance.
Congure a static route for a non-default VRF instance
• Congure a static route in a non-default VRF instance. Static routes contain IP addresses of the next-hop neighbors that are reachable
through the non-default VRF. These IP addresses could also belong to the interfaces that are part of the non-default VRF instance.
CONFIGURATION
ip route vrf vrf-name ip-address mask next-hop-ip-address or ipv6 route vrf vrf-name ipv6-
address prefix-length next-hp[=ipv6–address
For example: ip route vrf red 10.1.1.0/24 20.1.1.6 or ipv6 route vrf red 2::/64 3::1
• Congure the route to direct trac to a front-panel port in case of a non-default VRF instance.
CONFIGURATION
ip route ip-address-mask ethernet interface-type or ipv6 route ipv6–address-mask ethernet
interface-type
For example: ip route 10.1.1.0/24 ethernet 1/1/1 or ipv6 route 2::/64 ethernet 1/1/1. Where ethernet
1/1/1 is part of the non-default VRF.
Conguring static entry in IPv6 neighbor
• Congure a static entry in the IPv6 neighbor discovery.
CONFIGURATION
ipv6 neighbor vrf vrf–test 1::1 ethernet 1/1/1 xx:xx:xx:xx:xx:xx
VRF conguration
The following conguration illustrates a typical VRF setup:
Layer 3
287