Connectivity Guide

Example
OS10(conf-if-eth1/1/3)# lldp tlv-select basic-tlv system-name
Supported Releases 10.2.0E or later
lldp tlv-select dot1tlv
Enables or disables the dot.1 TLVs to transmit in LLDP packets.
Syntax
lldp tlv-select dot1tlv { port-vlan-id | link-aggregation}
Parameters
• port-vlan-id — Enter the port VLAN ID.
• link-aggregation — Enable the link aggregation TLV.
Default Enabled
Command Mode INTERFACE
Usage Information The lldp tlv-select dot1tlv link-aggregation command advertises link aggregation as a dot1 TLV
in the LLDPDUs. The no version of this command disables TLV transmissions.
Example (Port)
OS10(conf-if-eth1/1/3)# lldp tlv-select dot1tlv port-vlan-id
Example (Link
Aggregation)
OS10(conf-if-eth1/1/3)# lldp tlv-select dot1tlv link-aggregation
Supported Releases 10.2.0E or later
lldp tlv-select dot3tlv
Enables or disables the dot3 TLVs to transmit in LLDP packets.
Syntax
lldp tlv-select dot3tlv {macphy-config | max-framesize}
Parameters
• macphy-config — Enable the port VLAN ID TLV.
• max-framesize — Enable maximum frame size TLV.
Default Enabled
Command Mode INTERFACE
Usage Information The no version of this command disables TLV transmission.
Example
OS10(conf-if-eth1/1/3)# lldp tlv-select dot3tlv macphy-config
Supported Releases 10.2.0E or later
lldp transmit
Enables the transmission of LLDP packets on a specic interface.
Syntax
lldp transmit
Parameters None
208 Layer 2