Users Guide

IPv6 Access Control Lists (IPv6 ACLs)
IPv6 ACLs and IPv6 Route Map commands are supported on Dell Networking OS.
NOTE: For IPv4 ACL commands, see Access Control Lists (ACL).
Important Points to Remember
• Certain platforms require manual CAM usage space allotment. For more information, see cam-acl.
• Egress IPv6 ACL and IPv6 ACL on the Loopback interface is not supported.
• Reference to an empty ACL permits any trac.
• ACLs are not applied to self-originated trac (for example, Control Protocol trac not aected by IPv6 ACL because the routed bit is
not set for Control Protocol trac and for egress ACLs the routed bit must be set).
• You can use the same access list name for both IPv4 and IPv6 ACLs.
• You can apply both IPv4 and IPv6 ACLs on an interface at the same time.
• You can apply IPv6 ACLs on physical interfaces and a logical interfaces (Port-channel/VLAN).
• Non-contiguous masks are not supported in source or destination addresses in IPv6 ACL entries.
• Because the prex mask is specied in /x format in IPv6 ACLs, inverse mask is not supported.
Topics:
• show cam-acl-egress
• show cam-acl
• show ipv6 accounting access-list
• permit icmp
• permit
• ipv6 control-plane egress-lter
• ipv6 access-list
• cam-acl-egress
• cam-acl
show cam-acl-egress
Show information on FP groups allocated for egress ACLs.
Syntax
show cam-acl-egress
Command Modes
• EXEC
25
IPv6 Access Control Lists (IPv6 ACLs) 805