Users Guide
Verifying the DCB Conguration
To display DCB congurations, use the following show commands.
Table 20. Displaying DCB Congurations
Command Output
show qos dot1p-queue mapping
Displays the current 802.1p priority-queue mapping.
Displays the data center bridging status, number of PFC-enabled
ports, and number of PFC-enabled queues.
show interface port-type pfc {summary | detail}
Displays the PFC conguration applied to ingress trac on an
interface, including priorities and link delay.
To clear PFC TLV counters, use the clear pfc counters
interface port-type slot/port command.
show interface port-type pfc statistics
Displays counters for the PFC frames received and transmitted (by
dot1p priority class) on an interface.
You can use the show interface pfc statistics
command even without enabling DCB on the system.
show interface
port-type ets {summary | detail}
Displays the ETS conguration applied to egress trac on an
interface, including priority groups with priorities and bandwidth
allocation.
To clear ETS TLV counters, enter the clear ets counters
interface port-type slot/port command.
show interface port-type DCBx detail
Plays the DCBx conguration on an interface.
show
Displays the PFC conguration applied to ingress trac, including
priorities and link delay.
Displays the ETS conguration applied to ingress trac, including
priorities and link delay.
Examples of the show Commands
The following example shows the show dot1p-queue mapping command.
Dell(conf)# show qos dot1p-queue-mapping
Dot1p Priority: 0 1 2 3 4 5 6 7
Queue : 1 0 2 3 4 5 6 7
The following example shows the output of the show qos dcb-map test command.
Dell#show qos dcb-map test
-----------------------
State :Complete
PfcMode:ON
--------------------
PG:0 TSA:ETS BW:50 PFC:OFF
Priorities:0 1 2 5 6 7
PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3 4
The following example shows the show interfaces pfc summary command.
Dell# show interfaces tengigabitethernet 1/1/1/4 pfc summary
Interface TenGigabitEthernet 1/1/1/4
Data Center Bridging (DCB)
275