Administrator Guide

ROUTE-MAP
ROUTER BGP
BGP ADDRESS-FAMILY
ROUTER ISIS
ISIS ADDRESS-FAMILY
ROUTER OSPF
ROUTER OSPFV3
ROUTER RIP
SPANNING TREE
TRACE-LIST
VLT DOMAIN
VRRP
UPLINK STATE GROUP
GRUB
Navigating CLI Modes
The Dell EMC Networking OS prompt changes to indicate the CLI mode.
The following table lists the CLI mode, its prompt, and information about how to access and exit the CLI mode. Move linearly
through the command modes, except for the end command which takes you directly to EXEC Privilege mode and the exit
command which moves you up one command mode level.
NOTE: Sub-CONFIGURATION modes all have the letters conf in the prompt with more modifiers to identify the mode and
slot/port information.
Table 1. Dell EMC Networking OS Command Modes
CLI Command Mode Prompt Access Command
EXEC
DellEMC>
Access the router through the console
or terminal line.
EXEC Privilege
DellEMC#
● From EXEC mode, enter the enable
command.
● From any other mode, use the end
command.
CONFIGURATION
DellEMC(conf)#
● From EXEC privilege mode, enter the
configure command.
● From every mode except EXEC and
EXEC Privilege, enter the exit
command.
NOTE: Access all of the following
modes from CONFIGURATION
mode.
N/A N/A
AS-PATH ACL
DellEMC(config-as-path)# ip as-path access-list
10 Gigabit Ethernet Interface
DellEMC(conf-if-te-1/1/1/1)#
interface (INTERFACE modes)
25 Gigabit Ethernet Interface
DellEMC(conf-if-tf-1/1/1/1)#
interface(INTERFACE modes)
40 Gigabit Ethernet Interface
DellEMC(conf-if-fo-1/1/1)#
interface (INTERFACE modes)
50 Gigabit Ethernet Interface
DellEMC(conf-if-fi-1/1/1/1)#
interface(INTERFACE modes)
100 Gigabit Ethernet Interface
DellEMC(conf-if-hu-1/1/1)#
interface(INTERFACE modes)
Interface Group
DellEMC(conf-if-group)# interface(INTERFACE modes)
Interface Range
DellEMC(conf-if-range)#
interface (INTERFACE modes)
Loopback Interface
DellEMC(conf-if-lo-0)#
interface (INTERFACE modes)
Management Ethernet Interface
DellEMC(conf-if-ma-1/1)#
interface (INTERFACE modes)
Configuration Fundamentals 35