Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S6100-ON

191

192

193

194

195

196

197

198

199

200

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.10(0.0) Introduced on the S6100–ON.

9.8(1.0) Introduced on the Z9100–ON.

9.0.2.0 Introduced on the S6000.

8.4.2.1 Introduced on the S-Series.

8.2.1.0 Introduced on the E-Series TeraScale.

7.8.1.0 Introduced on the C-Series.

7.4.1.0 Introduced on the E-Series TeraScale Added the monitor option.

deny icmp

Configure a filter to drop all or specific ICMP messages.

Syntax

deny icmp {source address mask | any | host ipv6-address} {destination

address | any | host ipv6-address} [message-type] [count [byte]] | [log]

[monitor]

To remove this filter, you have two choices:

● Use the no seq sequence-number command syntax if you know the filter’s sequence number

● Use the no deny icmp {source address mask | any | host ipv6-address}

{destination address | any | host ipv6-address} command

Parameters

source address

Enter the IPv6 address of the network or host from which the packets were sent in

the x:x:x:x::x format followed by the prefix length in the /x format. The range is /0

to /128. The :: notation specifies successive hexadecimal fields of zero.

mask

Enter a network mask in /prefix format (/x).

any Enter the keyword any to specify that all routes are subject to the filter.

host

ipv6-

address

Enter the keyword host followed by the IPv6 address of the host in the x:x:x:x::x

format. The :: notation specifies successive hexadecimal fields of zero.

destination

address

Enter the IPv6 address of the network or host to which the packets are sent in the

x:x:x:x::x format followed by the prefix length in the /x format. The range is /0

to /128. The :: notation specifies successive hexadecimal fields of zero.

count (OPTIONAL) Enter the keyword count to count packets processed by the filter.

byte (OPTIONAL) Enter the keyword byte to count bytes processed by the filter.

Defaults Not configured.

Command Modes ACCESS-LIST