Concept Guide

One AS assigns the MED a value and the other AS uses that value to decide the preferred path. For this example, assume the MED is the
only attribute applied. In the following illustration, AS100 and AS200 connect in two places. Each connection is a BGP session. AS200 sets
the MED for its T1 exit point to 100 and the MED for its OC3 exit point to 50. This sets up a path preference through the OC3 link. The
MEDs are advertised to AS100 routers so they know which is the preferred path.
MEDs are non-transitive attributes. If AS100 sends an MED to AS200, AS200 does not pass it on to AS300 or AS400. The MED is a locally
relevant attribute to the two participating ASs (AS100 and AS200).
NOTE: The MEDs are advertised across both links, so if a link goes down, AS 1 still has connectivity to AS300 and AS400.
Figure 24. Multi-Exit Discriminators
NOTE
: Conguring the set metric-type internal command in a route-map advertises the IGP cost as MED to outbound
EBGP peers when redistributing routes. The congured set metric value overwrites the default IGP cost. If the outbound
route-map uses MED, it overwrites IGP MED.
Origin
The origin indicates the origin of the prex, or how the prex came into BGP. There are three origin codes: IGP, EGP, INCOMPLETE.
Origin Type
Description
IGP Indicates the prex originated from information learned through an interior gateway protocol.
EGP Indicates the prex originated from information learned from an EGP protocol, which NGP replaced.
INCOMPLETE Indicates that the prex originated from an unknown source.
Generally, an IGP indicator means that the route was derived inside the originating AS. EGP generally means that a route was learned from
an external gateway protocol. An INCOMPLETE origin code generally results from aggregation, redistribution, or other indirect ways of
installing routes into BGP.
In Dell EMC Networking OS, these origin codes appear as shown in the following example. The question mark (?) indicates an origin code
of INCOMPLETE (shown in bold). The lower case letter (i) indicates an origin code of IGP (shown in bold).
Example of Viewing Origin Codes
DellEMC#show ip bgp
BGP table version is 0, local router ID is 10.101.15.13
Status codes: s suppressed, d damped, h history, * valid, > best
Path source: I - internal, a - aggregate, c - confed-external, r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Border Gateway Protocol (BGP)
193