Administrator Guide

Add Ranges
The following example shows how to use commas to add VLAN and port-channel interfaces to the range.
Example of Adding VLAN and Port-Channel Interface Ranges
DellEMC(config-if-range-te-1/1/1/1-1/1/2/1)# interface range Vlan 2 – 100 , Port 1 – 25
DellEMC(config-if-range-te-1/1/1/1-1/1/2/1-vl-2-100-po-1-25)# no shutdown
DellEMC(config-if-range-hu-1/1/1-1/1/6)# interface range Vlan 2 – 100 , Port 1 – 25
DellEMC(config-if-range-hu-1/1/1-1/1/6-vl-2-100-po-1-25)# no shutdown
Defining Interface Range Macros
You can define an interface-range macro to automatically select a range of interfaces for configuration.
Before you can use the macro keyword in the interface-range macro command string, define the macro.
To define an interface-range macro, use the following command.
• Defines the interface-range macro and saves it in the running configuration file.
CONFIGURATION mode
define interface-range macro_name {vlan vlan_ID - vlan_ID | {{tengigabitethernet [/stack]
slot/port/[subport] - [/stack]slot/port/[subport] | fortyGigE} stack/slot/port/[subport] -
stack/slot/port/[subport]}} [ , {vlan vlan_ID - vlan_ID | {{tengigabitethernet [stack/slot/
port/subport - stack/slot/port/[subport] | fortyGigE} stack/slot/port/[subport] - stack/slot/
port/[subport]}}
Define the Interface Range
The following example shows how to define an interface-range macro named “test” to select Ten Gigabit Ethernet interfaces 5/1 through
5/4.
Example of the define interface-range Command for Macros
DellEMC(config)# define interface-range test tengigabitethernet 1/1/1/1 - 1/1/4/1
Choosing an Interface-Range Macro
To use an interface-range macro, use the following command.
• Selects the interfaces range to be configured using the values saved in a named interface-range macro.
CONFIGURATION mode
interface range macro name
The following example shows how to change to the interface-range configuration mode using the interface-range macro named “test.”
DellEMC(config)# interface range macro test
DellEMC(config-if)#
Monitoring and Maintaining Interfaces
Monitor interface statistics with the monitor interface command. This command displays an ongoing list of the interface status
(up/down), number of packets, traffic statistics, and so on.
To view the interface’s statistics, use the following command.
• View the interface’s statistics.
EXEC Privilege mode
Enter the type of interface and the interface information:
378
Interfaces