Administrator Guide

Dell#show interfaces tengigabitethernet 0/6
gigabitethernet 0/0 is up, line protocol is down
Hardware is DellEth, address is 90:b1:1c:f4:9a:fa
Current address is 90:b1:1c:f4:9a:fa
Pluggable media present, SFP type is 1GBASE
……………………
LineSpeed 1000 Mbit
Dell#show interfaces tengigabitethernet 0/7
gigabitethernet 0/0 is up, line protocol is down
Hardware is DellEth, address is 90:b1:1c:f4:9a:fa
Current address is 90:b1:1c:f4:9a:fa
Pluggable media present, SFP type is 1GBASE
……………………
LineSpeed 1000 Mbit
Dell#show interfaces tengigabitethernet 0/8
TenGigabitEthernet 0/0 is up, line protocol is up
Hardware is DellEth, address is 90:b1:1c:f4:9a:fa
Current address is 90:b1:1c:f4:9a:fa
Pluggable media present, QSFP type is 4x10GBASE-CR1-3M
……..
LineSpeed 10000 Mbit
The show inventory command shows the following output:
NOTE: In the following show inventory media command output, the port numbers 1, 2, 3, 5, 6, and 7 ports are
actually inactive. However, Dell Networking OS still shows that optical cables are inserted into these ports. This is a
software limitation for this release.
Dell# show inventory media
Slot Port Type Media Serial Number
-------------------------------------------------------------------
0 0 SFP+ 10GBASE-SX APF12420031B3P
0 1 SFP+ 10GBASE-SX APF12420031B3P
0 2 SFP+ 10GBASE-SX APF12420031B3P
0 3 SFP+ 10GBASE-SX APF12420031B3P
0 4 SFP 10GBASE-SX APF12420031B3P
0 5 SFP 10GBASE-SX APF12420031B3P
0 6 SFP 10GBASE-SX APF12420031B3P
0 7 SFP 10GBASE-SX APF12420031B3P
0 8 QSFP 4x10GBASE-CR1-3M APF12420031B3P
0 9 QSFP 4x10GBASE-CR1-3M APF12420031B3P
0 10 QSFP 4x10GBASE-CR1-3M APF12420031B3P
0 11 QSFP 4x10GBASE-CR1-3M APF12420031B3P
0 12 QSFP 40GBASE-SR4
Configuring wavelength for 10–Gigabit SFP+
optics
You can set the wavelength for tunable 10–Gigabit SFP+ optics using the wavelength command. To set the wavelength, follow these
steps:
• Enter the interface mode and set the wavelength.
INTERFACE mode
wavelength 1529.0
The wavelength range is from 1528.3 nm to 1568.77nm.
• Verify configuration changes.
INTERFACE mode
show config
380
Interfaces