Administrator Guide

Table 1. Dell EMC Networking OS Command Modes (continued)
CLI Command Mode Prompt Access Command
ECMP
DellEMC(conf-ecmp-group-ecmp-
group-id)#
ecmp-group
EIS
DellEMC(conf-mgmt-eis)# management egress-interface-
selection
FRRP
DellEMC(conf-frrp-ring-id)# protocol frrp
LLDP DellEMC(conf-lldp)# or
DellEMC(conf-if—interface-
lldp)#
protocol lldp (CONFIGURATION or
INTERFACE Modes)
LLDP MANAGEMENT INTERFACE
DellEMC(conf-lldp-mgmtIf)#
management-interface (LLDP
Mode)
LINE
DellEMC(config-line-console)
or DellEMC(config-line-vty)
line console orline vty
MONITOR SESSION
DellEMC(conf-mon-sess-
sessionID)#
monitor session
OPENFLOW INSTANCE
DellEMC(conf-of-instance-of-
id)#
openflow of-instance
PORT-CHANNEL FAILOVER-GROUP
DellEMC(conf-po-failover-
grp)#
port-channel failover-group
PRIORITY GROUP
DellEMC(conf-pg)# priority-group
PROTOCOL GVRP
DellEMC(config-gvrp)# protocol gvrp
QOS POLICY
DellEMC(conf-qos-policy-out-
ets)#
qos-policy-output
SUPPORTASSIST
DellEMC(support-assist)# support-assist
VLT DOMAIN
DellEMC(conf-vlt-domain)# vlt domain
VRRP
DellEMC(conf-if-interface-
type-slot/port-vrid-vrrp-
group-id)#
vrrp-group
u-Boot
Dell=>
Press any key when the following line
appears on the console during a system
boot: Hit any key to stop
autoboot:
UPLINK STATE GROUP
DellEMC(conf-uplink-state-
group-groupID)#
uplink-state-group
The following example shows how to change the command mode from CONFIGURATION mode to PROTOCOL SPANNING
TREE.
Example of Changing Command Modes
DellEMC(conf)#protocol spanning-tree 0
DellEMC(config-span)#
Configuration Fundamentals
37