Administrator Guide

Table 25. show interface DCBx detail Command Description (continued)
Field Description
Peer DCBx Status: Acknowledgment Number Acknowledgement number transmitted in Control TLVs
received from peer device.
Total DCBx Frames transmitted Number of DCBx frames sent from local port.
Total DCBx Frames received Number of DCBx frames received from remote peer port.
Total DCBx Frame errors Number of DCBx frames with errors received.
Total DCBx Frames unrecognized Number of unrecognizable DCBx frames received.
QoS dot1p Traffic Classification and Queue
Assignment
The following section describes QoS dot1P traffic classification and assignments.
DCB supports PFC, ETS, and DCBx to handle converged Ethernet traffic that is assigned to an egress queue according to the
following QoS methods:
Honor dot1p You can honor dot1p priorities in ingress traffic at the port or global switch level (refer to Default dot1p to
Queue Mapping) using the service-class dynamic dot1p command in INTERFACE configuration
mode.
Layer 2 class
maps
You can use dot1p priorities to classify traffic in a class map and apply a service policy to an ingress port
to map traffic to egress queues.
NOTE: Dell EMC Networking does not recommend mapping all ingress traffic to a single queue when using PFC and ETS.
However, Dell EMC Networking does recommend using Ingress traffic classification using the service-class dynamic
dot1p command (honor dot1p) on all DCB-enabled interfaces. If you use L2 class maps to map dot1p priority traffic to
egress queues, take into account the default dot1p-queue assignments in the following table and the maximum number of
two lossless queues supported on a port (refer to Configuring Lossless Queues).
Although Dell EMC Networking OS allows you to change the default dot1p priority-queue assignments (refer to Setting
dot1p Priorities for Incoming Traffic), DCB policies applied to an interface may become invalid if you reconfigure dot1p-
queue mapping. If the configured DCB policy remains valid, the change in the dot1p-queue assignment is allowed.
dot1p Value in
the Incoming
Frame
Egress Queue Assignment
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
Configuring the Dynamic Buffer Method
Priority-based flow control using dynamic buffer spaces is supported on the switch.
To configure the dynamic buffer capability, perform the following steps:
280
Data Center Bridging (DCB)