Administrator Guide

show feature
Verify the status of software applications, such as VRF, that are activated and running on a device.
Syntax
show feature
Command Modes
EXEC
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Updated the command to display the IPV6acloptimized feature on the S6100–
ON and Z9100–ON.
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.4(0.0) Introduced on the S4810, S4820T, and S6000.
Usage
Information
You can activate VRF application on a device by using the feature vrf command in CONFIGURATION
mode. The no feature vrf command is not supported on any of the platforms.
Example
DellEMC# show feature
Feature State
------------------------------
VRF Enabled
DellEMC#
Command Modes
To navigate and launch various CLI modes, use specific commands. Navigation to these modes is described in the following
sections.
BGP ADDRESS-FAMILY Mode
To enable or configure IPv4 for BGP, use BGP ADDRESS-FAMILY mode. For more information, see Border Gateway Protocol
IPv4 (BGPv4).
To enter BGP ADDRESS-FAMILY mode:
1. Verify that you are logged in to ROUTER BGP mode.
2. Enter the address-family command.
3. Enter the protocol type:
● For IPv4, enter the ipv4 multicast command. The prompt changes to include conf-router_bgp_af for IPv4.
CLASS-MAP Mode
To create or configure a class map, use CLASS-MAP mode. For more information, see Policy-Based QoS Commands.
CLI Basics
47