Administrator Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
Usage Information You must configure the VLT port channel interface which is connecting to the remote VLT domain as peer-
domain-link. You can also configure the VLANs you want to exclude from the VLT proxy gateway.
Example
DellEMC(conf)#vlt-domain 1
DellEMC(conf-vlt-domain)#proxy-gateway lldp
DellEMC(conf-vlt-domain-proxy-gw-lldp)#peer-domain-link port-channel 20
exclude-vlan 3
proxy-gateway peer-timeout
Enables the VLT node to timeout the transmission of the peer MAC address when the VLT peer is down.
Syntax
[no] peer-timeout value
Parameters
value Enter the timeout value (in seconds). The range is from 1 to 65535. The default is
infinity.
Default Infinity
Command Modes VLT DOMAIN PROXY GW LLDP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Removed the default value on the S-Series and Z-Series.
9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL Switch.
Usage Information When a VLT peer goes down, the local VLT node stops sending its peer’s MAC address. If you configure this
timeout, the local VLT node sends its peer's MAC address until the timer expires.
Use this timer when you enable vlt-peer-mac transmit. A typical use example is a square VLT topology
with a single link connecting to the remote peers.
Example
DellEMC(conf-vlt-domain-proxy-gw-lldp)# peer-timeout 5
1582 VLT Proxy Gateway