Administrator Guide
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced support for telnetting to the VRRP group IP address assigned using this
command.
6.2.1.1 Introduced on the E-Series.
Usage Information
The VRRP group only becomes active and sends VRRP packets when you configure a virtual IP address. When
you delete the virtual address, the VRRP group stops sending VRRP packets.
A system message appears after you enter or delete the virtual-address command.
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s virtual IP address with the
same address as the interface’s primary IP address and change the priority of the VRRP group to 255.
You can ping the virtual IP addresses configured in all VRRP groups.
vrrp delay minimum
Set the delay time for VRRP initialization after an interface comes up.
Syntax
vrrp delay minimum seconds
Parameters
seconds
Enter the number of seconds for the delay for VRRP initialization after an interface
becomes operational. The range is from 0 to 900 (0 indicates no delay).
Defaults 0
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information
This command applies to a single interface. When you use this command with the vrrp delay reload
command, the later timer rules VRRP enabling. For example, if vrrp delay reload is 600 and vrrp delay
minimum is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are
up and configured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface reload, the system waits 300
seconds (5 minutes) to bring up VRRP on that interface.
1634 Virtual Router Redundancy Protocol (VRRP)