Users Guide

Usage
Information
The no version of this command removes the weight factor from the WRED profile.
Example
OS10(config)# wred test_wred
OS10(config-wred)# random-detect weight 10
Supported
Releases
10.4.0E(R1) or later
service-policy
Configures the input and output service policies.
Syntax
service-policy {input | output} [type {qos | queuing | network-qos}]
policy-map-name
Parameters
● input—Enter to assign a QoS policy to the interface input.
● output—Enter to assign a QoS policy to the interface output.
● qos—Enter to assign a qos type policy-map.
● queuing—Enter to assign the queuing type policy-map.
● network-qos—Enter to assign the network-qos type policy-map.
● policy-map-name—Enter the policy-map name up to a maximum of 32 characters.
Default Not configured
Command Mode INTERFACE
Usage
Information
Attach only one policy-map to the interface input and output for each qos and queuing policy-map
type. You can attach four service-policies to the system QoS—one each for qos, queueing, and
network-qos type policy-maps. When you configure interface-level policies and system-level policies,
the interface-level policy takes precedence over the system-level policy.
To apply the network-QoS policy to a single interface or a range of interfaces, perform the following
steps:
1. Run the interface ethernet or interface range ethernet command to select a single or
a range of upstream and downstream interfaces, respectively.
2. Run the service-policy input type network-qos command to apply the network-QoS
policy only to the selected interfaces.
Ensure you do not apply the policy in the global SYSTEM-QoS mode because it might cause CRC errors
on the remote-end fiber channel devices.
Example
OS10(conf-if-eth1/1/7)# service-policy input type qos p1
Supported
Releases
10.2.0E or later
set cos
Sets a cost of service (CoS) value to mark L2 802.1p (dot1p) packets.
Syntax
set cos cos-value
Parameters cos-value — Enter a CoS value, from 0 to 7.
Default Not configured
Command Mode POLICY-MAP-CLASS-MAP
Usage
Information
You cannot enter two set statements with the same action-type. If you enter two set statements with
the same action-type, the second statement overwrites the first. When class-map type is qos, the
qos-group corresponds to data queues 0 to 7.
Quality of service 1591