Users Guide

Configuration notes
All Dell EMC PowerSwitches:
● Obscure password (service obscure-password) is enabled by default when upgrading to 10.5.2.0 or later if the
setting is not changed before the upgrade.
● If the Obscure password configuration is explicitly disabled before the upgrade, it remains disabled after the upgrade as well.
User management commands
disable
Lowers the privilege level.
Syntax
disable privilege-level
Parameters
● privilege-level—Enter the privilege level, from 0 to 15.
Defaults 1
Command Mode Privileged EXEC
Usage
Information
If you do not specify a privilege level, the system assigns level 1.
Example
OS10# disable
OS10# disable 6
Supported
Releases
10.4.3.0 or later
enable
Enables a specific privilege level.
Syntax
enable privilege-level
Parameters
● privilege-level—Enter the configured privilege level, from 0 to 15.
Defaults 15
Command Mode Exec
Usage
Information
Dell EMC Networking recommends configuring a password for privilege level 15 using the enable
password command. If you do not configure a password for a level, you can switch to that level without
entering a password, unless a password is configured for a highest intermediate level. If you configure a
password for an intermediate level, enter that password when prompted. To access privilege level 15, you
must configure the enable password command. If you do not configure a password for privilege level
15, you cannot enter level 15. For privilege levels 0 to 14, the enable password command is optional.
Privilege levels inherit all permitted commands from all lower levels. For example, if you log in to privilege
level 10 using the enable 10 command, all commands that are assigned to privilege level 10 and lower
are available for use.
Example
OS10# enable
OS10# enable 10
Supported
Releases
10.4.3.0 or later
1308 Security