Owners Manual
– 81h-mandatory password test failed. Wrong password size.
Firewall
To set a rewall, use the set firewall configuration command. Use parameters 0–3 to add the iptables rules and 4–7 to remove
the iptables rules.
• NetFN—0x32
• Command—0x76
• Request data Byte 1—parameter selector
• Request data Byte 2—State selector
• Request data Byte 3:N—Conguration parameter data
• Response data Byte 1—Completion code
– 80h—Parameter not supported
– 81h—Invalid time (start/stop time)
– 82h—Attempt to write read-only parameter
– 83h—Attempt to access HTTP Port 80
To set the rewall conguration state, use the following:
Table 2. Firewall set parameters
Type specic param # Parameter data
To set the command to DROP 00 Parameter to drop packets. Parameter 0–3
uses this state to add the rules to drop the
packets based on the IP address/port
number or ange of IP addresses/port
numbers.
Use parameter 4–7 to remove the rule.
To set the command to ACCEPT 01 Parameter to accept packets. Parameter 0–
3 uses this state to add the rules to accept
the packets based on the IP address/port
number or ange of IP addresses/port
numbers.
Use parameter 4–7 to remove the rule.
To set the rewall parameters, use the following:
Table 3. Firewall parameters
Parameter # Parameter data
Add the IPv4 address rule 0 Data 1:4—IP address
MS-byte rst. This is an IPv4 address that is
blocked or unblocked based on the state.
Add the range of IPv4 addresses rule 1 Data 1:8—IP address range
[1:4]—Starting IP address from which IPs
are blocked or unblocked based on the state.
20 Conguration methods