Connectivity Guide

------------------------
* 1 primary
2 secondary
Supported Releases 10.2.0E or later
show vlt vlt-port-detail
Displays detailed status information about VLT ports.
Syntax
show vlt id vlt-port-detail
Parameters id — Enter a VLT domain ID, from 1 to 255.
Default Not congured
Command Mode EXEC
Usage Information The * in the mismatch output indicates a local node entry.
Example
OS10# show vlt 1 vlt-port-detail
Vlt-port-channel ID : 1
VLT Unit ID Port-Channel Status Configured ports Active ports
---------------------------------------------------------------------
* 1 port-channel1 down 2 0
2 port-channel1 down 2 0
VLT ID : 2
VLT Unit ID Port-Channel Status Configured ports Active ports
---------------------------------------------------------------------
* 1 port-channel2 down 1 0
2 port-channel2 down 1 0
VLT ID : 3
VLT Unit ID Port-Channel Status Configured ports Active ports
---------------------------------------------------------------------
2 port-channel3 down 1 0
Supported Releases 10.2.0E or later
vlt-domain
Creates a VLT domain.
Syntax
vlt-domain domain-id
Parameter domain-id — Enter a VLT domain ID on each peer, from 1 to 255.
Default None
Command Mode CONFIGURATION
Usage Information Congure the same VLT domain ID on each peer. If a VLT domain ID mismatch occurs on VLT peers, the VLTi link
between peers does not activate. The no version of this command disables VLT.
Example
OS10(config)# vlt-domain 1
Supported Releases 10.2.0E or later
Virtual Link Trunking 855