Service Manual

• Enable or disable LACP on any LAN port.
INTERFACE mode
[no] port-channel-protocol lacp
The default is LACP disabled.
This command creates context.
• Configure LACP mode.
LACP mode
[no] port-channel number mode [active | passive | off]
• number: cannot statically contain any links.
The default is LACP active.
• Configure port priority.
LACP mode
[no] lacp port-priority priority-value
The range is from 1 to 65535 (the higher the number, the lower the priority).
The default is 32768.
LACP Configuration Tasks
The following are LACP configuration tasks.
• Creating a LAG
• Configuring the LAG Interfaces as Dynamic
• Setting the LACP Long Timeout
• Monitoring and Debugging LACP
Creating a LAG
To create a dynamic port channel (LAG), use the following command. First you define the LAG and then the
LAG interfaces.
• Create a dynamic port channel (LAG).
CONFIGURATION mode
interface port-channel
• Create a dynamic port channel (LAG).
CONFIGURATION mode
switchport
Link Aggregation Control Protocol (LACP) 602