Service Manual

Getting Started

This chapter helps you get started using the S5000.

Accessing Ports

The S5000 has two management ports available for system access — a console port and a universal serial bus

(USB)-B port.

The USB-B port acts the same as the console port. The terminal settings are the same for both access ports.

Accessing the RJ-45/RS-232 Console

Port

The RS-232/RJ-45 console port is labeled on the lower left-hand side of the S5000 system as you face the

Utility side of the chassis.

NOTE

: Before starting this procedure, be sure that you have a terminal emulation program already

installed on your PC.

Figure 2. RS-232/RJ-45 Console Port

To access the console port, follow these steps.

1 Install an RJ-45 copper cable into the console port. Use a rollover (crossover) cable to connect the

S5000 console port to a terminal server.

2 Connect the other end of the cable to the DTE terminal server.

3 Terminal settings on the console port cannot be changed in the software and are set as follows:

Getting Started 52