Users Guide

Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
Though the system does not generate a route due to backdoor config, there is an option for injecting/
sourcing a local route in presence of network backdoor config on a learned route.
redistribute
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static} command.
Parameters
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.
static Enter the keyword static to redistribute manually configured routes. These
routes are treated as incomplete routes.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name of an
established route map. Only the following ROUTE-MAP mode commands are
supported:
● match ipv6 address
● match ipv6 next-hop
● match ipv6 route-source
● set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
If you do not configure the default-metric command, in addition to the redistribute command,
or there is no route map to set the metric, the metric for redistributed static and connected is “0”.
To redistribute the default route (0::0/0), configure the neighbor default-originate command.
Related
Commands
neighbor default-originate – injects the default route.
890 IPv6 Border Gateway Protocol (IPv6 BGP)