Users Guide

IPv6 Access Control Lists (IPv6 ACLs)
IPv6 ACLs and IPv6 Route Map commands are supported on Dell Networking OS.
NOTE: For IPv4 ACL commands, see Access Control Lists (ACL).
Important Points to Remember
● Certain platforms require manual CAM usage space allotment. For more information, see cam-acl.
● Egress IPv6 ACL and IPv6 ACL on the Loopback interface is not supported.
● Reference to an empty ACL permits any traffic.
● ACLs are not applied to self-originated traffic (for example, Control Protocol traffic not affected by IPv6 ACL because the
routed bit is not set for Control Protocol traffic and for egress ACLs the routed bit must be set).
● You can use the same access list name for both IPv4 and IPv6 ACLs.
● You can apply both IPv4 and IPv6 ACLs on an interface at the same time.
● You can apply IPv6 ACLs on physical interfaces and a logical interfaces (Port-channel/VLAN).
● Non-contiguous masks are not supported in source or destination addresses in IPv6 ACL entries.
● Because the prefix mask is specified in /x format in IPv6 ACLs, inverse mask is not supported.
Topics:
• IPv6 ACL Commands
• cam-acl
• cam-acl-egress
• clear counters ipv6 access-group
• deny
• deny icmp
• deny tcp
• deny udp
• ipv6 access-group
• ipv6 control-plane egress-filter
• ipv6 access-list
• permit
• permit icmp
• permit tcp
• permit udp
• remark
• resequence access-list
• resequence prefix-list ipv6
• seq
• show cam-acl
• show cam-acl-egress
• show config
• show ipv6 accounting access-list
• show running-config acl
• test cam-usage
• IPv6 Route Map Commands
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• route-map
28
IPv6 Access Control Lists (IPv6 ACLs) 791