Users Guide

18:32:48.168 O> 0192 525f5252 44594661 696c7572 65733b4f 7065722e 55736572
506f7274 2e302e34
R_RRDYFailures;Oper.UserPort.0.4
18:32:48.168 O> 0224 2e466c6f 77457272 6f72733b 4f706572 2e557365 72506f72
742e302e 342e5368
.FlowErrors;Oper.UserPort.0.4.Sh
18:32:48.168 O> 0256 6f727446 72616d65 73496e3b 4f706572 2e557365 72506f72
742e302e 342e4c6f
ortFramesIn;Oper.UserPort.0.4.Lo
18:32:48.168 O> 0288 6e674672 616d6573 496e3b4f 7065722e 55736572 506f7274
2e302e34 2e433634
ngFramesIn;Oper.UserPort.0.4.C64
--More--
Example of the show file flash Command
Dell#show file flash://TRACE_LOG_DIR/fc_console.log
U-Boot 2012.04(Dell)
Built by build at tools-sjc-01 on Sat Mar 9 13:25:54 2013
S5000 Boot Selector Label 1.3.0.0m
CPU0: P2020, Version: 2.1, (0x80e20021)
Core: E500, Version: 5.1, (0x80211051)
Clock Configuration:
CPU0:1200 MHz, CPU1:1200 MHz,
CCB:600 MHz,
DDR:330 MHz (660 MT/s data rate) (Asynchronous), LBC:37.500 MHz
L1: D-cache 32 kB enabled
I-cache 32 kB enabled
Board: S5000 FC CPU
CPLD: S5000 CPLD Rev 41
I2C: ready
SPI: ready
DRAM: Detected RDIMM VL33B5263F-K9S
Detected 4096 MB of memory
This U-Boot only supports < 4G of DDR
You could rebuild it with CONFIG_PHYS_64BIT
2 GiB (DDR3, 64-bit, CL=6, ECC off)
--More--
Configuring the Fibre Channel Port
Group in Passthrough Ethernet Mode
To configure a Fibre Channel port group to enable Passthrough Ethernet mode, use the following
commands.
1 Configure a Fibre Channel port group to enable Passthrough Ethernet mode.
CONFIGURATION mode
stack-unit unit-number port-group number portmode ethernet
2 Change the Fibre Channel mode.
no stack-unit unit-number port-group number portmode ethernet
CONFIGURATION mode
Fibre Channel Interface 419