Reference Guide

Command History

Version 9.0(1.3) Introduced on the S5000.

Commands

telnet – telnets to another device.

ip tftp source-interface

Assign an interface’s IP address in outgoing packets for TFTP traffic.

S5000

Syntax

ip tftp source-interface type slot/port

Parameters

source-

interface

type

slot/port

Enter the source-interface keyword followed by the interface

type and slot/port or number information. Valid slot numbers are 0-11.

The valid port numbers for each interface type are listed below.

• For a 10-Gigabit Ethernet interface, enter the keyword

tengigabitethernet followed by slot/port numbers.

The port range is 0 to 63.

• For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE followed by slot/port numbers. The ports are 48,

52, 56, and 60.

• For a Loopback interface, enter the keyword loopback

followed by a number from 0 to 16383.

• For a Port Channel interface, enter the keywords port-

channel followed by a number from 1 to 128.

• For a VLAN interface, enter the keyword vlan followed by a

VLAN id number from 1 to 4094.

Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing

packets.

Command Modes CONFIGURATION

Command History

Version 9.0(1.3) Introduced on the S5000.