Reference Guide

set extcommunity soo
Use this feature to set extended community site-of-origin in Route Map.
S5000
Syntax
set extcommunity soo {as4 ASN4:NN | ASN:NNNN | IPADDR:NN [non-
trans]}
To delete the site-of-origin community, use the no set extcommunity command.
Parameters
as4 ASN4:NN Enter the keyword as4 followed by the 4-octet AS specific extended
community number in the format ASN4:NN (4-byte AS number:2-byte
community value).
ASN:NNNN Enter the 2-octet AS specific extended community number in the
format ASN:NNNN (2-byte AS number:4-byte community value).
IPADDR:NN Enter the IP address specific extended community in the format
IPADDR:NN (4-byte IPv4 Unicast Address:2-byte community value).
non-trans (OPTIONAL) Enter the keywords non-trans to indicate a non-
transitive BGP extended community.
Defaults none
Command Modes ROUTE MAP (config-route-map)
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If the set community rt and soo are in the same route-map entry, the behavior defines as:
• If the rt option comes before soo, with or without the additive option, soo
overrides the communities set by rt.
• If the rt option comes after soo, without the additive option, rt overrides the
communities set by soo.
• If the rt with the additive option comes after soo, rt adds the communities set
by soo.
Related
Commands
set extcommunity rt – sets the extended community route origins using the route-map.
368