Reference Guide

booted: Upgrade the stack using the image with which the master switch
booted up.
flash: After the keyword flash:, enter the location of the source file in the
internal flash in the format: //file-pathname or press Enter to
launch a prompt sequence.
ftp: After the keyword ftp:, enter the location of the source file in the
format: //userid:password@host-ip-address/file-
pathname
or press Enter to launch a prompt sequence.
tftp: After the keyword tftp:, enter the location of the source file in the
format: //host-ipaddress/file—pathname or press Enter to
launch a prompt sequence.
usbflash: After the keyword usbflash:, enter the location of the source file
in the format: //file-pathname or press Enter to launch a
prompt sequence.
file-path Enter the path and filename to be used to upgrade the boot image.
Defaults none
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must reload the stack after entering the upgrade boot stack-unit command to
boot up stack units with the new boot code.
Example
FTOS#upgrade boot bootselector-image stack-unit all booted
Password:
Current BootSelector information in the system:
===============================================================
Card BootSelector Current Version New Version
---------------------------------------------------------------
Unit0 Boot Selector 1.3.0.0m 1.3.0.0m
Unit7 Boot Selector 1.3.0.0m 1.3.0.0m
Unit8 Boot Selector 1.3.0.0m 1.3.0.0m
Unit9 Boot Selector 1.3.0.0m 1.3.0.0m
***************************************************************
* Warning - Upgrading boot selectors is inherently risky and *
* should only be attempted when necessary. A failure at this *
* upgrade may cause a board RMA. Proceed with caution ! *
***************************************************************
Proceed Boot Selector image for all units [yes/no]: yes
Programming
!.!.!.!.!!.!.!.!.!!.!.!.!.!.!.!!.!.!.!.!!.!.!.!.!.!!.!.!.!.!.!!
.!.
Bootselector image upgrade for all completed successfully.
FTOS#
1240