Reference Guide

Defaults Disabled. If enabled without the level or number-of-buffers options specified,
level = 2 and number-of-buffers = 20 are the defaults.
Command
Modes
LINE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
When you enable logging synchronous, unsolicited messages appear between
software prompts and outputs. Only the messages with a severity at or below the
set level are sent to the console.
If the message queue limit is reached on a terminal line and messages are
discarded, a system message appears on that terminal line. Messages may continue
to appear on other terminal lines.
Related
Commands
logging on — enables logging.
logging trap
Specify which messages are logged to the Syslog server based the message severity.
Syntax
logging trap [level]
To return to the default values, use the default logging trap command.
To disable logging, use the no logging trap command.
Parameters
level Indicate a value from 0 to 7 or enter one of the following
parameters: emergencies, alerts, critical, errors,
Simple Network Management Protocol (SNMP) and Syslog
1931