Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Introduced on the E-Series.
Usage
Information
The running router sets the remaining time value to the current adjacency hold
time. You can override this setting by implementing this command.
Override the default restart-wait time by entering the no graceful-restart
restart-wait
command. When you disable restart-wait, the current
adjacency hold time is used.
Set the t3 timer to adjacency on the restarting router when implementing this
command. The restarting router gets the remaining time value from its peer and
adjusts its T3 value so only when you have configured graceful-restart t3
adjacency
.
Related
Commands
graceful-restart restart-wait — enables the graceful restart maximum wait time
before a restarting peer comes up.
graceful-restart restart-wait
Enable the graceful restart maximum wait time before a restarting peer comes up.
Syntax
NOTE: Set the t3 timer to adjacency on the restarting router when
implementing this command.
graceful-restart restart-wait seconds
To return to the default, use the no graceful-restart restart-wait
command.
Parameters
seconds Enter the graceful restart time in seconds. The range is from
5 to 300 seconds. The default is 30 seconds.
1224
Intermediate System to Intermediate System (IS-IS)