Reference Guide

rejected-sa Enter the keyword rejected-sa to clear the cache source-active
entries that are rejected because the RPF check failed, an SA filter or
limit is configured, the RP or MSDP peer is unreachable, or because
of a format error.
local Enter the keyword local to clear out local PIM advertised entries. It
applies the redistribute filter (if present) while adding the local PIM
SA entries to the SA cache.
Defaults Without any options, this command clears the entire source-active cache.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.1 Introduced on the S4810.
Version 7.8.1.0 Added the local option.
Version 7.7.1.0 Added the rejected-sa option.
Version 6.2.1.1 Introduced
debug ip msdp
Turn on MSDP debugging.
S4820T
Syntax
debug ip msdp {event peer address | packet peer address | pim}
To turn debugging off, use the no debug ip msdp {event peer address |
packet peer address | pim} command.
Parameters
event peer
address
Enter the keyword event then the peer address in a dotted decimal
format (A.B.C.D.).
packet peer
address
Enter the keyword packet then the peer address in a dotted
decimal format (A.B.C.D.).
pim Enter the keyword pim to debug advertisement from PIM.
Defaults Not configured.
Command Modes EXEC Privilege
883