Reference Guide

stack-unit stack-group
Configure a stacking group specified by an ID.
S4820T
Syntax
[no] stack-unit unit-id stack-group stack-group-id
Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID. The range is from 0 to 16.
[no] Use no stack-unit unit-id stack-group stack-id
to remove the current stack group configuration.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.10.2 Introduced on the S4810.
Usage
Information
WARNING: The following message displays to confirm the command: All non-
default configurations on the related member ports ports
(<ports listed here>) will be removed. Do you want to
continue (y/n)? If you enter “y”, all non-default configurations on any member
ports of the current stack group is removed when the unit is rebooted.
vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
S4820T
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
1393