Reference Guide

default logging trap
Return to the default settings for logging messages to the Syslog servers.
S4820T
Syntax
default logging trap
Defaults level = 6 or informational
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related
Commands
logging trap — limit messages logged to the Syslog servers based on severity.
logging
Configure an IP address or host name of a Syslog server where logging messages are sent. Multiple logging servers of
both IPv4 and/or IPv6 can be configured.
S4820T
Syntax
logging {ip-address | ipv6-address | hostname}
To disable logging, use the no logging command.
Parameters
ip-address Enter the IPv4 address in dotted decimal format.
ipv6-address Enter the IPv6 address in the x:x:x:x::X format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
hostname Enter the name of a host already configured and recognized by the
switch.
Defaults Disabled.
Command Modes CONFIGURATION
1296