API Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4248FB-ON /S4248FBL-ON

781

782

783

784

785

786

787

788

789

790

AG1(config)# vlt-domain 255

AG1(conf-vlt-255)# backup destination 10.16.132.147

AG1(conf-vlt-255)# discovery-interface ethernet1/1/31:1,1/1/31:4

AG1(conf-vlt-255)# peer-routing

AG1(conf-vlt-255)# primary-priority 1

AG1(conf-vlt-255)# vlt-mac 00:00:00:11:11:11

AG1(conf-vlt-255)# exit

AG1(config)# interface ethernet 1/1/32:1

AG1(conf-if-eth1/1/32:1)# no shutdown

AG1(conf-if-eth1/1/32:1)# no switchport

AG1(conf-if-eth1/1/32:1)# ip address 16.0.0.1/24

AG1(conf-if-eth1/1/32:1)# flowcontrol receive off

AG1(conf-if-eth1/1/32:1)# ip pim sparse-mode

AG1(conf-if-eth1/1/32:1)# ip ospf 100 area 0.0.0.0

AG1(conf-if-eth1/1/32:1)# exit

AG1(config)# interface vlan 11

AG1(conf-if-vlan-11)# no shutdown

AG1(conf-if-vlan-11)# ip address 11.0.0.1/24

AG1(conf-if-vlan-11)# ip pim sparse-mode

AG1(conf-if-vlan-11)# ip pim dr-priority 1000

AG1(conf-if-vlan-11)# ip ospf 100 area 0.0.0.0

AG1(conf-if-vlan-11)# ip ospf cost 3000

AG1(conf-if-vlan-11)# exit

AG1(config)# interface vlan 12

AG1(conf-if-vlan-12)# no shutdown

AG1(conf-if-vlan-12)# ip address 12.0.0.1/24

AG1(conf-if-vlan-12)# ip pim sparse-mode

AG1(conf-if-vlan-12)# ip pim dr-priority 10

AG1(conf-if-vlan-12)# ip ospf 100 area 0.0.0.0

AG1(conf-if-vlan-12)# exit

AG1(config)# interface vlan 13

AG1(conf-if-vlan-13)# no shutdown

AG1(conf-if-vlan-13)# ip address 13.0.0.1/24

AG1(conf-if-vlan-13)# ip pim sparse-mode

AG1(conf-if-vlan-13)# ip pim dr-priority 10

AG1(conf-if-vlan-13)# ip ospf 100 area 0.0.0.0

AG1(conf-if-vlan-13)# ip ospf cost 4000

AG1(conf-if-vlan-13)# exit

AG1(config)# interface loopback 101

AG1(conf-if-lo-101)# no shutdown

AG1(conf-if-lo-101)# ip address 101.0.0.1/32

AG1(conf-if-lo-101)# ip pim sparse-mode

AG1(conf-if-lo-101)# ip ospf 100 area 0.0.0.0

AG1(conf-if-lo-101)# exit

AG1(config)# interface port-channel11

AG1(conf-if-po-11)# no shutdown

AG1(conf-if-po-11)# switchport mode trunk

AG1(conf-if-po-11)# switchport trunk allowed vlan 11

AG1(conf-if-po-11)# vlt-port-channel 11

AG1(conf-if-po-11)# exit

AG1(config)# interface port-channel12

AG1(conf-if-po-12)# no shutdown

AG1(conf-if-po-12)# switchport mode trunk

AG1(conf-if-po-12)# switchport access vlan 1

AG1(conf-if-po-12)# switchport trunk allowed vlan 12

AG1(conf-if-po-12)# vlt-port-channel 12

AG1(conf-if-po-12)# exit

AG1 和接口的 PIM 邻居以到达邻居

show ip pim neighbor 命令将显示 AG1 和接口的 PIM 邻居以到达邻居。

AG1# show ip pim neighbor

Neighbor Address Interface Uptime/Expires Ver DR Priority / Mode

----------------------------------------------------------------------

多播

789