API Guide

OS10(config-nve-ovsdb)# max-backoff 10000
OS10(config-nve-ovsdb)# exit
5. Assign interfaces to be managed by the controller.
OS10(config)# interface ethernet 1/1/54:3
OS10(config-if-eth1/1/54:3)# switchport mode trunk
OS10(config-if-eth1/1/54:3)# no switchport access vlan
OS10(config-if-eth1/1/54:3)# nve-controller
6. (Optional) Enable BFD.
OS10(config)# bfd enable
VTEP 2
1. Configure the OSPF protocol in the underlay.
OS10# configure terminal
OS10(config)# router ospf 1
OS10(config)# exit
OS10(config)# interface ethernet 1/1/23:1
OS10(config-if-eth1/1/23:1)# no switchport
OS10(config-if-eth1/1/23:1)# ip ospf 1 area 0.0.0.0
OS10(config-if-eth1/1/23:1)# exit
2. Configure a Loopback interface.
OS10(config)# interface loopback 1
OS10(config-if-lo-1)# no shutdown
OS10(config-if-lo-1)# ip address 202.0.0.1/32
OS10(config-if-lo-1)# exit
3. Create an NVE instance and configure a Loopback interface as the VXLAN source tunnel interface.
OS10(config)# nve
OS10(config-nve)# source-interface loopback 1
4. Specify the NSX controller reachability information.
OS10(config-nve)# controller ovsdb
OS10(config-nve-ovsdb)# ip 10.16.140.182 port 6640 ssl
OS10(config-nve-ovsdb)# max-backoff 10000
OS10(config-nve-ovsdb)# exit
5. Assign interfaces to be managed by the controller.
OS10(config)# interface ethernet 1/1/25:3
OS10(config-if-eth1/1/25:3)# switchport mode trunk
OS10(config-if-eth1/1/25:3)# no switchport access vlan
OS10(config-if-eth1/1/25:3)# nve-controller
6. (Optional) Enable BFD.
OS10(config)# bfd enable
Verify the controller configuration
VTEP 1
To view controller-based information on the VTEP 1, use the show nve controller command.
OS10# show nve controller
Management IP : 10.16.140.11/16
VXLAN
997