API Guide
link-bundle-utilization trigger-threshold
Configures a threshold value to trigger traffic monitoring distribution on an ECMP link bundle.
Syntax
link-bundle-utilization trigger-threshold value
Parameters value — Enter a link bundle trigger threshold value, from 0 to 100.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command disables the configuration.
Example
OS10(config)# link-bundle-utilization trigger-threshold 80
Supported
Releases
10.2.0E or later
load-balancing
Distributes or load balances incoming traffic using the default parameters in the hash algorithm.
Syntax
load-balancing {ingress-port enable | [tcp-udp-selection l4–destination-
port | l4–source-port] | [ip-selection destination-ip | source-ip |
protocol | vlan-id | l4–destination-port | l4–source-port] | [ipv6–
selection destination-ip | source-ip | protocol | vlan-id | l4–destination-
port | l4–source-port] | [mac-selection destination-mac | source-mac |
ethertype | vlan-id]}
Parameters
● ingress-port enable — Enables load-balancing on ingress ports.
● tcp-udp-selection — Enables the TCP UDP port for the load-balancing configuration.
● ip-selection — Enables IPv4 key parameters to use in the hash computation.
● ipv6-selection — Enables IPV6 key parameters to use in hash computation.
● destination-ip — Enables the destination IP address in the hash calculation.
● source-ip — Enables the source IP address in the hash calculation.
● protocol — Enables protocol information in the hash calculation.
● vlan-id — Enables VLAN ID information in the hash calculation.
● l4-destination-port — Enables Layer 4 (L4) destination port information in the hash
calculation.
● l4-source-port — Enables L4 source port information in the hash calculation.
● mac-selection — Enables MAC load-balancing configurations.
● destination-mac— Enables destination MAC information in the hash calculation.
● source-mac— Enables source MAC information in the hash calculation.
● ethertype — Enables Ethernet type information in the hash calculation.
Default
● ip-selelection—source—ip dest-ip vlan-id l4–source-port l4–dest-port ipv4
protocol
● ipv6-selection—source—ipv6 dest-ipv6 vlan—id l4–source-port l4–dest-port
ipv6 protocol
● mac-selection—source—mac destination—mac vlan-id ethertype
● tcp-udp-selection—l4–source-port l4–dest-port
Command Mode CONFIGURATION
Usage
Information
● IPv4– selection: source-ip destination-ip protocol vlan-id l4-destination-port
l4-source-port
● IPv6 destination address: source-ip destination-ip protocol vlan-id l4-
destination-port l4-source-port
Layer 3 657