Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4148U-ON
251252253254255256257258259260
Table Of Contents
pool netdhcp1
lease infinite
network 35.1.1.0/24
!
pool netdhcp2
network 40.1.1.0/24
OS10# show ip interface brief
Interface Name IP-Address OK Method Status
Protocol
======================================================================================
===
Ethernet 1/1/1 unassigned YES unset up
up
Ethernet 1/1/2 unassigned YES unset up
up
…
Ethernet 1/1/32 unassigned NO unset up down
…
To resolve this issue, you must:
1. Configure a matching interface for pool netdhcp2-40.1.1.1/24 matches 40.1.1.0/24.
OS10(config)# interface ethernet 1/1/2
OS10(conf-if-eth1/1/2)# no shutdown
OS10(conf-if-eth1/1/2)# no switchport
OS10(conf-if-eth1/1/2)# ip address 40.1.1.1/24
2. Run the show ip interface brief command to verify if an IP address is assigned to ethernet 1/1/2 port.
OS10# show ip interface brief
Interface Name IP-Address OK Method Status
Protocol
====================================================================================
=====
Ethernet 1/1/1 unassigned YES unset up
up
Ethernet 1/1/2 40.1.1.1/24 YES manual up
up
…
3. Re-enable the DHCP server because it failed to start initially.
OS10# configure terminal
OS10(config)# ip dhcp server
OS10(config-dhcp)# disable
OS10(config-dhcp)# no disable
OS10(config-dhcp)#
Configuration notes
All Dell EMC PowerSwitches except MX-Series, S4200-Series, S5200 Series, and Z9332F-ON:
●
Before you configure a DHCP address pool, you must configure a DHCP server interface with an IP address in the range
that is used in the DHCP address pool. If you configure the DHCP address pool first, and then configure a DHCP server
interface, to enable automatic DHCP address allocation, you must restart the DHCP service using the disable and no disable
commands. Select one of the choices for successfully configuring a DHCP address pool:
○ Configure manual binding for a host/hardware MAC address in the IP address range that is used for the DHCP pool.
○ Configure a network statement with a valid IP address range.
● DHCP client is enabled by default on the management interface. The management interface automatically tries to obtain an
IP address from a DHCP server. To manually configure an IP address on the management port, disable the DHCP client using
the no ip address dhcp command in Interface mode
● The DHCP server does not start unless at least one interface matches one of the configured network pools. An interface
matches a network pool when you include the IP address in the subnet that is defined for that network pool. For example, an
interface with IP address 10.1.1.1/24 matches a pool that is configured with network 10.1.1.0/24.
Packet format and options
The DHCP server listens on port 67 and transmits to port 68. The DHCP client listens on port 68 and transmits to port 67.
System management
259