Connectivity Guide

• Conguration contains information about how to enter CONFIGURATION mode, how to modify the candidate conguration, and so on.
• Security contains information about how to add users, troubleshoot RADIUS, how to view current DHCP information, and so on.
• Layer 2 contains information about how to congure routing information including 802.1X, LACP, LLDP, MAC, and so on.
• Layer 3 contains information about how to troubleshoot BCP, ECMP, OSPF, and so on.
• System management contains information about how to view current interface conguration information, how to view a list of all
system devices, how to view the software version, and so on.
• Quality of service contains information about quality of service including classication and marking, congestion management, policing
and shaping, and so on.
• Monitoring contains information about how to view alarms, events, logs, and so on.
Installation
How do I congure a default management route?
Although the default management route was congured during installation, you can use the route add default gw command from
the Linux shell to congure the default management IP address for routing. SupportAssist requires the default management route is
congured to work properly, as well as DNS congured and a route to a proxy server. For more information, see Congure SupportAssist
and proxy-server.
How do I log into the OS10 shell as the system administration?
Use linuxadmin as the username and password to enter OS10 at root level.
Where can I nd additional installation information for my specic device?
See the Setup Guide shipped with your device or the platform-specic Installation Guide on the Dell EMC Support page at dell.com/
support.
Hardware
What are the default console settings for ON-Series devices?
• Set the data rate to 115200 baud
• Set the data format to 8 bits, stop bits to 1, and no parity
• Set ow control to none
How do I view the hardware inventory?
Use the show inventory command to view complete system inventory.
How do I view the process-related information?
Use the show processes node-id node-id-number [pid process-id] command to view the process CPU utilization
information.
Conguration
How do I enter CONFIGURATION mode?
Use the configure terminal command to change from EXEC mode to CONFIGURATION mode.
I made changes to the running conguration le but the updates are not showing. How do I view my changes?
Troubleshoot OS10
979