Connectivity Guide

• If the iSCSI login request is received on a non-VLT interface, followed by a response from a VLT interface, the connection is associated
with the VLT LAG interface and the information about the session synchronizes with the VLT peer.
• When a VLT interconnect comes up, information about iSCSI sessions learnt on the VLT LAG exchanges between the VLT-peers.
iSCSI commands
iscsi aging
Sets the aging time for monitored iSCSI sessions.
Syntax
iscsi aging [time minutes]
Parameters time minutes — Enter the aging time in minutes allowed for monitoring iSCSI sessions, from 5 to 43,200.
Default 10 minutes
Command Mode CONFIGURATION
Usage Information Congure the aging time allowed for monitored iSCSI sessions on TCP ports before the session closes. The no
version of this command disables the aging time.
Example
OS10(config)# iscsi aging time 30
Supported Releases 10.3.0E or later
iscsi enable
Enables iSCSI auto-detection of attached storage arrays and switch auto-conguration.
Syntax
iscsi enable
Parameter None
Default
None
Command Mode CONFIGURATION
Usage Information
iSCSI optimization automatically detects storage arrays and auto-congures switch ports with the iSCSI
parameters received from a connected device. The no version of this command disables iSCSI auto-detection.
Starting from release 10.4.1.1, when you perform a fresh installation of OS10, iSCSI autocong is enabled and
owcontrol receive is set to on. However, when you upgrade from an earlier release to release 10.4.1.1 or later, the
existing iSCSI conguration is retained and the owcontrol receive could be set to on or o, depending on the
iSCSI conguration before upgrade.
Example
OS10(config)# iscsi enable
Supported Releases 10.3.0E or later
Converged data center services 895