Connectivity Guide

openow
Enters OPENFLOW conguration mode.
Syntax
openflow
Parameters None
Default None
Command Mode CONFIGURATION
Usage Information
All OpenFlow congurations are performed in this mode.
The no form of this command prompts a switch reload. If you enter yes, the system deletes all OpenFlow
congurations and the switch returns to the normal mode after the reload.
Example
OS10# configure terminal
OS10(config)# openflow
OS10 (config-openflow)#
Supported Releases 10.4.1 or later
probe-interval
Congures the echo request interval, in seconds, for the controller congured with the logical switch instance.
Syntax
probe-interval interval
Parameters interval—Enter the amount of time, in seconds, between the keepalive messages, also known as echo
requests, from 1 to 65,535.
Default 5 seconds
Command Mode OPENFLOW SWITCH CONFIGURATION
Usage Information None
Example
OS10 (config)# openflow
OS10 (config-openflow)# switch of-switch-1
OS10 (config-openflow-switch)# probe-interval 20
OS10 (config-openflow-switch)#
Supported Releases 10.4.1 or later
protocol-version
Species protocol version the logical switch interface uses.
Syntax
protocol-version version
Parameters version—Choose from one of the following:
OpenFlow 683