Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4112F-ON/S4112T-ON
331332333334335336337338339340
Table Of Contents
Interfaces
You can configure and monitor physical interfaces (Ethernet), port-channels, and virtual local area networks (VLANs) in Layer 2
(L2) or Layer 3 (L3) modes.
Table 52. Interface types
Interface type Supported Default mode Requires creation Default status
Ethernet (PHY) L2, L3 unset No no shutdown enabled
Management N/A N/A No no shutdown enabled
Loopback L3 L3 Yes no shutdown enabled
Port-channel L2, L3 unset Yes no shutdown enabled
VLAN L2, L3 L3 Yes, except default no shutdown enabled
Configuration notes
● All Dell EMC PowerSwitches except MX-Series, S4200-Series, S5200 Series, and Z9332F-ON:
○ To avoid loops in an L2 network with statically configured port channels, keep the no switchport configuration on an
interface after you remove its port-channel configuration using the no interface port-channel command.
○ On a S4148-ON switch, 10GBASE-T transceiver cannot operate at 100M or 1G speed.
● S3048-ON platform: During reload of S3048-ON, copper GbE ports transiently become operationally up for around 2
seconds, and then they go down. This is a known hardware behavior.
● When the 1GBASE-T optic is plugged on a 100G port using a QSA adapter on a device and the RJ45 end is plugged into the
copper port of the peer, there is a slight delay during the link up or down events.
Ethernet interfaces
Ethernet port interfaces are enabled by default. To disable an Ethernet interface, use the shutdown command. Use the show
interface status command to view the status of the interfaces.
NOTE:
Linux operation or commands such as shutdown or no-shutdown and ip-address that are run against the interface is
not reflected in the CLI.
To reenable a disabled interface, use the no shutdown command.
1. Configure an Ethernet port interface from Global CONFIGURATION mode.
interface ethernet node/slot/port[:subport]
2. Disable and reenable the Ethernet port interface in INTERFACE mode.
shutdown
no shutdown
Disable Ethernet port interface
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# shutdown
Enable Ethernet port interface
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# no shutdown
10
Interfaces 337