Connectivity Guide

Table Of Contents
Usage Information None
Example
OS10(config)# system qos
OS10(config-sys-qos)#
Supported Releases 10.2.0E or later
trust-map
Congures trust map on an interface or on system QoS.
Syntax
trust—map {dot1p | dscp} {default | trust-map-name}
Parameters
dot1p — Apply dot1p trust map.
dscp — Apply dscp trust map.
default — Apply default dot1p or dscp trust map.
trust-map-name — Enter the name of trust map.
Default Disabled
Command Mode
INTERFACE
SYSTEM-QoS
Usage Information Use this command to apply the trust map on interface or System QoS. The no version of this command removes
the applied trust map from the interface or System QoS.
Example
OS10(config)# interface ethernet 1/1/10
OS10(conf-if-eth1/1/10)# trust-map dot1p default
OS10(conf-if-eth1/1/10)# trust-map dot1p d1
OS10(config)# interface ethernet 1/1/2
OS10(conf-if-eth1/1/2)# trust-map dscp default
OS10(conf-if-eth1/1/2)# trust-map dscp d2
OS10(config)# system qos
OS10(config-sys-qos)# trust-map dot1p default
OS10(config-sys-qos)# trust-map dscp d2
Supported Releases 10.4.1.0 or later
trust dot1p-map
Creates a user-dened trust map for dot1p ows.
Syntax
trust dot1p-map map-name
Parameters map-name — Enter the name of the dot1p trust map. A maximum of 32 characters.
Default Not congured
Command Mode CONFIGURATION
Usage Information If you enable trust, trac obeys the dot1p map. default-dot1p-trust is a reserved trust-map name. The no
version of this command returns the value to the default.
Quality of service 827