Connectivity Guide

3 snmp_user 114 0 0 0 2017-07-10T23:58:39Z
4 snmp_user 57 0 0 0 2017-07-10T23:58:40Z
6 admin 17 0 0 4 2017-07-12T03:55:18Z
*7 admin 10 0 0 0 2017-07-12T04:42:55Z
OS10#
Supported Releases 10.3.1E or later
Telnet server
To allow Telnet TCP/IP connections to an OS10 switch, enable the Telnet server. The OS10 Telnet server uses the Debian telnetd
package. By default, the Telnet server is disabled.
When you enable the Telnet server, connect to the switch using the IP address congured on the management or any front-panel port. The
Telnet server conguration is persistent and is maintained after you reload the switch. To verify the Telnet server conguration, enter the
show running-configuration command.
Enable Telnet server
OS10(config)# ip telnet server enable
Disable Telnet server
OS10(config)# no ip telnet server enable
By default, the Telnet server is disabled on the default virtual routing and forwarding (VRF). To congure the Telnet server to be reachable
on the management VRF, use the ip telnet server vrf management command.
Congure Telnet server on management VRF
OS10(config)# ip telnet server vrf management
Telnet commands
ip telnet server enable
Enables Telnet TCP/IP connections to an OS10 switch.
Syntax
ip telnet server enable
Parameters None
Default Disabled
Command Mode CONFIGURATION
Usage Information By default, the Telnet server is disabled. When you enable the Telnet server, use the IP address congured on the
management or any front-panel port to connect to an OS10 switch. After you reload the switch, the Telnet server
conguration is maintained. To verify the Telnet server conguration, use the show running-configuration
command.
Example
OS10(config)# ip telnet server enable
Example (disable)
OS10(config)# no ip telnet server enable
Supported Releases 10.4.0E(R1) or later
612 System management