Connectivity Guide

show ipv6 ospf interface
Displays the congured OSPFv3 interfaces. You must enable OSPFv3 to display the output.
Syntax
show ipv6 ospf interface interface [vrf vrf-name]
Parameters
• interface — (Optional) Enter the interface information:
– ethernet — Physical interface, from 1 to 48.
– port-channel — Port-channel interface, from 1 to 128.
– vlan — VLAN interface, from 1 to 4093.
• vrf vrf-name — (Optional) Enter the keyword vrf followed by the name of the VRF to display the
congured OSPFv3 enabled interfaces in that VRF.
Default Not congured
Command Mode EXEC
Example
OS10# show ipv6 ospf interface
ethernet1/1/1 is up, line protocol is up
Link Local Address fe80::20c:29ff:fe0a:d59/64, Interface ID 5
Area 0.0.0.0, Process ID 200, Instance ID 0, Router ID 10.0.0.2
Network Type broadcast, Cost: 1
Transmit Delay is 1 sec, State BDR, Priority 1
BFD enabled(Interface level) Interval 300 Min_rx 300 Multiplier 3 Role Active
Designated Router on this network is 2.2.2.2
Backup Designated router on this network is 10.0.0.2 (local)
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 2.2.2.2(Designated Router)
Supported Releases 10.3.0E or later
show ipv6 ospf neighbor
Displays a list of OSPFv3 neighbors connected to the local router.
Syntax
show ipv6 ospf [vrf vrf-name] neighbor
Parameters
• vrf vrf-name — Enter the keyword vrf followed by the name of the VRF to display a list of OSPFv3
neighbors in that VRF.
Default Not congured
Command Mode EXEC
Usage Information
• Neighbor ID—Displays the neighbor router ID.
• Pri—Displays the priority assigned neighbor.
• State—Displays the OSPF state of the neighbor.
• Dead Time—Displays the expected time until the system declares the neighbor dead.
• Interface ID—Displays the neighbor interface ID
• Interface—Displays the interface type, node/slot/port or number information.
Example
OS10(conf-if-eth1/1/1)# show ipv6 ospf neighbor
Neighbor ID Pri State Dead Time Interface ID Interface
486 Layer 3