Connectivity Guide

ipv6 nd hop-limit
Sets the hop limit advertised in RA messages and included in IPv6 data packets sent by the router.
Syntax
ipv6 nd hop-limit hops
Parameters
• hop-limit hops — Enter the maximum number of hops allowed for RA messages, from 0 to 255.
Defaults 64 hops
Command Mode INTERFACE
Usage Information The congured hop limit is advertised in RA messages and included in IPv6 data packets sent by the router. 0
indicates that no hop limit is specied by the router.
Example
OS10(config)# interface ethernet 1/2/3
OS10(conf-if-eth1/2/3)# ipv6 nd hop-limit 100
Supported Releases 10.4.0E(R1) or later
ipv6 nd managed-cong-ag
Sends RA messages that tell hosts to use stateful address autoconguration, such as DHCPv6, to obtain IPv6 addresses.
Syntax
ipv6 nd managed-config-flag
Parameters None
Defaults Not congured
Command Mode INTERFACE
Usage Information The no version of this command disables the managed-config-flag option in RA messages.
Example
OS10(config)# interface ethernet 1/2/3
OS10(conf-if-eth1/2/3)# ipv6 nd managed-config-flag
Supported Releases 10.4.0E(R1) or later
ipv6 nd max-ra-interval
Sets the maximum time interval between sending RA messages.
Syntax
ipv6 nd max-ra-interval seconds
Parameters
• max-ra-interval seconds — Enter a time interval in seconds, from 4 to 1800.
Defaults 600 seconds
Command Mode INTERFACE
Usage Information The no version of this command restores the default time interval used to send RA messages.
Example
OS10(config)# interface ethernet 1/2/3
OS10(conf-if-eth1/2/3)# ipv6 nd max-ra-interval 300
406 Layer 3