Connectivity Guide

Usage Information The no version of this command disables the conguration.
Example
OS10(config)# link-bundle-trigger-threshold 80
Supported Releases 10.2.0E or later
load-balancing
Distributes or load balances incoming trac using the default parameters in the hash algorithm.
Syntax
load-balancing {ingress-port enable | [tcp-udp-selection l4–destination-port |
l4–source-port] | [ip-selection destination-ip | source-ip | protocol | vlan-id
| l4–destination-port | l4–source-port] | [ipv6–selection destination-ip |
source-ip | protocol | vlan-id | l4–destination-port | l4–source-port] | [mac-
selection destination-mac | source-mac | ethertype | vlan-id]}
Parameters
• ingress-port enable — Enables load-balancing on ingress ports.
• tcp-udp-selection — Enables the TCP UDP port for the load-balancing conguration.
• ip-selection — Enables IPv4 key parameters to use in the hash computation.
• ipv6-selection — Enables IPV6 key parameters to use in hash computation.
• destination-ip — Enables the destination IP address in the hash calculation.
• source-ip — Enables the source IP address in the hash calculation.
• protocol — Enables protocol information in the hash calculation.
• vlan-id — Enables VLAN ID information in the hash calculation.
• l4-destination-port — Enables Layer 4 (L4) destination port information in the hash calculation.
• l4-source-port — Enables L4 source port information in the hash calculation.
• mac-selection — Enables MAC load-balancing congurations.
• destination-mac— Enables destination MAC information in the hash calculation.
• source-mac— Enables source MAC information in the hash calculation.
• ethertype — Enables Ethernet type information in the hash calculation.
Default
• ip-selelection—source—ip dest-ip vlan-id l4–source-port l4–dest-port ipv4
protocol
• ipv6-selection—source—ipv6 dest-ipv6 vlan—id l4–source-port l4–dest-port ipv6
protocol
•
mac-selection—source—mac destination—mac vlan-id ethertype
• tcp-udp-selection—l4–source-port l4–dest-port
Command Mode CONFIGURATION
Usage Information
• IPv4– selection: source-ip destination-ip protocol vlan-id l4-destination-port l4-
source-port
• IPv6 destination address: source-ip destination-ip protocol vlan-id l4-destination-
port l4-source-port
•
MAC parameters: source-mac destination-mac ethertype vlan-id
• TCP/UDP parameters: l4-destination-port l4-source-port
The no version of this command resets the value to the default.
Layer 3 387