Connectivity Guide

Supported Releases 10.2.0E or later
dot1x timeout supp-timeout
Sets the number of seconds that the device waits for the supplicant to respond to an EAP request frame before the device retransmits the
frame.
Syntax
dot1x timeout supp-timeout seconds
Parameters supp-timeout seconds — Enter the number of seconds for the 802.1X supplicant timeout, from 1 to 65535.
Default 30 seconds
Command Mode INTERFACE
Usage Information The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout supp-timeout 45
Supported Releases 10.2.0E or later
dot1x timeout tx-period
Sets the number of seconds that the device waits for a response to an EAP-request/identity frame from the supplicant before
retransmitting the request.
Syntax
dot1x timeout tx-period seconds
Parameters tx-period seconds — Enter the number of seconds for the 802.1X transmission timeout, from 1 to 65535.
Default 60 seconds
Command Mode INTERFACE
Usage Information The no version of this command resets the value to the default.
Example
OS10(conf-range-eth1/1/7-1/1/8)# dot1x timeout tx-period 120
Supported Releases 10.2.0E or later
show dot1x
Displays global 802.1X conguration information.
Syntax
show dot1x
Parameters None
Default Not congured
Command Mode EXEC
Usage Information None
Example
OS10# show dot1x
PAE Capability: Authenticator only
Protocol Version: 2
System Auth Control: Enable
Auth Server: Radius
Layer 2 173