Users Guide

Assign Router ID
You can assign a router ID for the OSPFv3 process. Configure an arbitrary value in the IP address format for each router. Each
router ID must be unique. Use the fixed router ID for the active OSPFv3 router process. Changing the router ID brings down the
existing OSPFv3 adjacency. The new router ID becomes effective immediately.
● Assign the router ID for the OSPFv3 process in ROUTER-OSPFv3 mode.
router-id ip-address
Assign router ID
OS10(config)# router ospfv3 100
OS10(config-router-ospfv3-100)# router-id 10.10.1.5
View OSPFv3 Status
OS10# show ipv6 ospf
Routing Process ospfv3 100 with ID 10.10.1.5
It is an Area Border Router
Min LSA origination 5000 msec, Min LSA arrival 1000 msec
Min LSA hold time 0 msec, Max LSA wait time 0 msec
Number of area in this router is 2, normal 2 stub 0 nssa
Area (0.0.0.0)
Number of interface in this area is 1
SPF algorithm executed 42 times
Area (0.0.0.1)
Number of interface in this area is 1
SPF algorithm executed 42 times
Configure Stub Areas
Type 5 LSAs are not flooded into stub areas. The ABR advertises a default route into the stub area where it is attached. Stub
area routers use the default route to reach external destinations.
1. Enable OSPFv3 routing and enter ROUTER-OSPFv3 mode, from 1 to 65535.
router ospfv3 instance number
2. Configure an area as a stub area in ROUTER-OSPFv3 mode.
area area-id stub [no-summary]
● area-id — Enter the OSPFv3 area ID as an IP address in A.B.C.D format or number, from 1 to 65535.
● no-summary — (Optional) Enter to prevent an ABR from sending summary LSAs into the stub area.
Configure Stub Area
OS10(config)# router ospfv3 10
OS10(conf-router-ospf-10)# area 10.10.5.1 stub no-summary
View Stub Area Configuration
OS10# show running-configuration ospfv3
!
interface ethernet1/1/3
ipv6 ospf 65 area 0.0.0.2
!
router ospfv3 65
area 0.0.0.2 stub no-summary
OS10# show ipv6 ospf database
OSPF Router with ID (199.205.134.103) (Process ID 65)
Router Link States (Area 0.0.0.2)
966
Layer 3