Users Guide

timers throttle lsa all
Configures the LSA transmit intervals.
Syntax
timers lsa all [start-interval | hold-interval | max-interval]
Parameters
● start-interval — Sets the minimum interval between initial sending and re-sending the same
LSA in milliseconds, from 0 to 600,000.
● hold-interval — Sets the next interval to send the same LSA in milliseconds. This is the time
between sending the same LSA after the start-interval is attempted, from 1 to 600,000.
● max-interval — Sets the maximum amount of time the system waits before sending the LSA in
milliseconds, from 1 to 600,000.
.
Default
● start-interval — 0 milliseconds
● hold-interval — 5000 milliseconds
● max-interval — 5000 milliseconds
Command Mode ROUTER-OSPF
Usage
Information
The no version of this command removes the LSA transmit timer.
Example
OS10(config)# router ospf 10
OS10(conf-router-ospf-10)# timers throttle lsa all 100 300 1000
Supported
Releases
10.2.0E or later
OSPFv3
OSPFv3 is an IPv6 link-state routing protocol that supports IPv6 unicast address families (AFs). OSPFv3 is disabled by default.
You must configure at least one interface, either physical or Loopback. The OSPF process automatically starts when OSPFv3 is
enabled for one or more interfaces. Any area besides area 0 can have any number ID assigned to it.
Enable OSPFv3
1. Enable OSPFv3 globally and configure an OSPFv3 instance in CONFIGURATION mode.
router ospfv3 instance-number
2. Enter the interface information to configure the interface for OSPFv3 in INTERFACE mode.
interface ethernet node/slot/port[:subport]
3. Enable the interface in INTERFACE mode.
no shutdown
4. Disable the default switchport configuration and remove it from an interface or a LAG port in INTERFACE mode.
no switchport
5. Enable the OSPFv3 on an interface in INTERFACE mode.
ipv6 ospfv3 process-id area area-id
● process-id — Enter the OSPFv3 process ID for a specific OSPFv3 process, from 1 to 65535.
● area-id — Enter the OSPF area ID as an IP address in A.B.C.D format or number, from 1 to 65535.
964
Layer 3