Users Guide
1.1.1.5 00:00:00:00:00:05 vlan100 port-channel1000
1.1.1.6 00:00:00:00:00:06 vlan100 port-channel1000 pv 10
Example (IP
Address)
OS10# show ip arp 192.168.2.2
Address Hardware address Interface Egress Interface
--------------------------------------------------------------------
192.168.2.2 90:b1:1c:f4:a6:e6 ethernet1/1/49:1 ethernet1/1/49:1
Example (Static)
OS10# show ip arp summary
Total Entries Static Entries Dynamic Entries
-------------------------------------------------------
3994 0 3994
OS10# show ip arp 192.168.2.2
Address Hardware address Interface Egress Interface
--------------------------------------------------------------------
192.168.2.2 90:b1:1c:f4:a6:e6 ethernet1/1/49:1 ethernet1/1/49:1
OS10# show ip arp
Address Hardware address Interface Egress Interface
---------------------------------------------------------------------------
192.168.2.2 90:b1:1c:f4:a6:e6 ethernet1/1/49:1 ethernet1/1/49:1
193.168.2.3 54:bf:64:e6:d4:c5 vlan4000 port-channel1000
Example
(Dynamic)
OS10# show ip arp dynamic
Address Hardware address Interface Egress Interface
---------------------------------------------------------------------------------
192.168.2.2 90:b1:1c:f4:a6:e6 ethernet1/1/49:1 ethernet1/1/49:1
193.168.2.3 54:bf:64:e6:d4:c5 vlan4000 port-channel1000
Supported
Releases
10.2.0E or later
show ip route
Displays IP route information.
Syntax
show ip route [vrf vrf-name] [all | bgp | connected | ospf process-id | static | ip-prefix/mask|
summary] load-balancing {ingress-port enable | [tcp-udp-selection l4–destination-port | l4–source-
port] | [ip-selection destination-ip | source-ip | protocol | vlan-id | l4–destination-port | l4–
source-port] | [ipv6–selection destination-ip | source-ip | protocol | vlan-id | l4–destination-port |
l4–source-port] | [mac-selection destination-mac | source-mac | ethertype | vlan-id]}
Parameters
● vrf vrf-name — (Optional) Enter vrf and then the VRF name to list the routes in the route table of a specific VRF.
● all — (Optional) Displays both active and non-active IP routes.
● bgp — (Optional) Displays BGP route information.
● connected — (Optional) Displays only the directly connected routes.
● ospf process-id — (Optional) Displays route information for the OSPF process, from 1 to 65535.
● static — (Optional) Displays static route information.
● ip-prefix/mask — (Optional) Displays routes for the destination prefix list.
NOTE: This option works only for the exact prefix and the mask length.
● summary — (Optional) Displays an IP route summary.
Default Not configured
Command Mode EXEC
Usage
Information
None
Layer 3 897